| Step | | Procedure & Parts & Tools |
| 1 |
|
EMPTY THE TANK. LOCATE THE MACHINE TOOL THAT WAS ATTACHED TO THE KEY RING OF YOUR MACHINE. THIS TOOL WILL BE USED TO OPEN THE MACHINE. IF YOU DO NOT HAVE THIS TOOL, YOU CAN USE A LONG FLAT TIP SCREWDRIVER.
|
| 2 |
|
LOCATE THE LABEL ON THE LEFT SIDE OF MACHINE (STANDING IN OPERATOR POSITION). FOLLOW THE DIRECTIONS ON THE LABEL TO OPEN THE MACHINE.
|
| 3 |
|
FOLLOWING THE DIRECTIONS ON THE LABEL, INSERT THE MACHINE TOOL INTO THE MACHINE. LIFT UP ON TANK TO OPEN MACHINE.
|
| 4 |
|
LOCATE THE SOLUTION PUMPS. PULL TO DISCONNECT THE WIRE CONNECTORS. CUT AND CRIMP NEW CONNECTORS ON IF NEEDED. TO REPLACE WIRE, CUT WIRE BACK 1/4 INCH AND USE PROPER WIRE CONNECTORS. CLOSE MACHINE WHEN FINISHED.
| Wire crimper |
|
|